Adjusting the Electric plane Base

Adjusting the  Electric plane Base


Base of Electric Hand Plane Set to zero It is almost new, but the base is distorted Use a glass surface plate for correction sand paper Polish the base to remove distortion. Become flat. Soon, this Benchtop Jointer will be renewed.
It’s going to be great !! Since the base was shaved, the blade became higher. Adjust the blade height. Turn the screw to change the blade height. Make it the same height as the base. Sharpen the wood to see the blade height. You can see the asymmetry of the blade height by looking at the wood chips stuck to the blade. Fine tuning I was able to adjust.

25 thoughts on “Adjusting the Electric plane Base

Leave a Reply

Your email address will not be published. Required fields are marked *