Serpentine belt (alternator/fan belt) sudah tiba masa untuk ditukar. – #MULO Jom DIY!!!

Serpentine belt (alternator/fan belt) sudah tiba masa untuk ditukar. – #MULO Jom DIY!!!


Okay… Today I plan to change serpentine belt Because I just received it.
Last time I bought it online. The belt need to be fixed here So Tools that I need Spanner size 17, steel rod because of
my spanner is not long enough I got a short spanner So I need it to ease my job later Opss, the view is not very clear Wait, I want to show you
what’s need to be done I put the spanner there The view is hard to be displayed Becasue the space is too tight Once you get there next Grab the iron rood place it like this push it When you pressed it, You can see the belt loose I need two hands to dismantle the belt Do it slowly and carefully Okay Done Release the tensioner slowly Damn.. It is stuck down here Okay.. I was successful to make
it done But, based on my observation the belt is still in a good shape but if refer to the manual it stated 80,000 KM need to
be replaced So now it supposed to be replaced Becasue I was late, and make it
more than 80,000KM Because last time,
this part was detained in customs So I have no time to do and today i got time to install it Even though it looks good Its okay, since i bought a new one This is a new belt Try to measure it Same length Alright Let’s install the new one Can you see that? There is a slot there Push it like this like this Pinch it a little bit push the belt In between the slot after that there is pulley down there
you just simply place it there Okay, i did pushed the belt inside but I want to show you once the belt entered simply pushed the belt until it reached
a pulley down there Ok done the installation By following this diagram Can you see it? Alright now only one pulley left This one I want to insert it here So i need to push the tensioner So that the belt will loose I need two hands to do this Okay settled See behind this one settled So we try to start the engine
but before that don’t forget to take out the spanner otherwise something else
going to happen Alright Alright, the new belt
done installed. There is no abnormal noise Everything is okay Sorry i can’t show you in details because now it’s late in the evening tonight i want to go back No matter what happens
I need to replace it now Since the old belt still in a good
shape I checked the condition still okay
to be used so in case of any emergency suddenly my belt broken better I keep this belt in
the trunk So that I can replace it on the spot

One thought on “Serpentine belt (alternator/fan belt) sudah tiba masa untuk ditukar. – #MULO Jom DIY!!!

Leave a Reply

Your email address will not be published. Required fields are marked *